Kurobox NAS-Central Forums

Welcome to the Kuro Community
It is currently Fri Jun 22, 2018 7:10 am

All times are UTC-06:00




Forum locked  This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
PostPosted: Thu Oct 18, 2007 8:47 pm 
Offline

Joined: Mon Aug 20, 2007 1:20 pm
Posts: 10
Hey Gents,

I may have bricked my Kuro Pr. I was trying to solder on a pin header to the UART port to use for console cable to redo my U-Boot. The cable didn't work so after some fiddling I powered down my Kuro. Now when I boot it the power LED flashes 18 times, the link LED stays steady, the error LED quickly flashes once with a short beep then it powers off.

I've since cleaned up my soldering and inspected for burned out parts from soldering iron but can't make out anything.

Also, if I hold in the reset buttong while booting, it plays a tune then the power and link LEDs go steady and it stays this way until manually powered off.


Can I revive this thing?


Top
   
Display posts from previous:  Sort by  
Forum locked  This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC-06:00


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited