Try this at your own risk
dd if=u-boot-lsppchg-flash-1.2.0-r2.bin of=/dev/fl2 bs=1k
174+1 records in
174+1 records out
Setup a net console (netcat) on your pc. (you might need to change the ip)
nc -u -p 6666 -v -v 192.168.11.150 6666
184.108.40.206: inverse host lookup failed:
(UNKNOWN) [220.127.116.11] 6666 (?) open
Reboot your kuro... When the kuro comes back up you should see some output in your net console, However the procompilled UBoot binary we used is looking for the incorrect image name.
*Settings below are corrrect for the gentoo image*
We need to halt the uboot process and change some environment vars.
Press s to stop the uboot process.
=> printenv hdfile
=> setenv hdfile boot/vmlinux.UBoot
setenv hdfile boot/vmlinux.UBoot
Seems to take a while to finaly come up, go and get a coffee or a beer